Toshiba SV685 - Manual (Page 57)

57
PROBLEM SOLVING
a
Set the Colour to Auto and exit.
b
Go to the PICTURE menu and adjust the tint.
Q
Why is the soundtrack in English when a different
audio language has been selected?
A The programme is currently being broadcast with an
English soundtrack only.
Q
Why is there incorrect or no sound when in DTV
mode?
A Press s to ensure the hard of hearing option has
not been selected.
Q
What is DVB-T?
A Digital Video Broadcast via an aerial/antenna.
Q
What is DVB-C?
A Digital Video Broadcast via a cable connection.
Q
How are radio channels selected?
A Press ATV/DTV on the remote control and select DTV
RADIO . Alternatively select from the GUIDE.
Q
What can be done if the PIN number has been
forgotten?
A Use the Master PIN code of 1276, then change to a
number of your choice. Ensure that no-one else can
use the Master PIN by removing the Owner’s
Manual.
Q
Why are there vertical stripes on the screen when in
PC mode?
A The Sampling Clock may need adjustment. Select PC
Settings from the SETUP menu, highlight Sampling
Clock and adjust until the lines clear.
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A The Clock Phase may need adjustment. Select PC
Settings from the SETUP menu, highlight Clock Phase
and adjust until the picture clears.
Q
Why when digital subtitles have been selected are
they not showing on screen?
A Subtitles are not currently being transmitted by the
broadcaster.
Q
Why are there problems with analogue text?
A Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the main index page of the text service
and look for the User Guide. This will explain the
basic operation of text in some detail. If further
information is needed on how to use text see the text
section.
Q
Why is a page number visible at the top of the screen
but no text?
A Text has been selected but Teletext information is
currently unavailable on the current source.
Q
Why are the colours wrong when an NTSC source is
played?
A Connect the source via a SCART lead and play.
Select Manual Settings from the SETUP menu.
Q
Why don't the devices connected via HDMI operate
properly?
A Make sure to use cables with the HDMI logo
(see page 9).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new
standard adoption. Try switching the HDMI settings
Lip Sync and INSTAPORT™ to Off.
Q
Why don't the REGZA-LINK devices work?
A When the connected REGZA-LINK device does not
work correctly after you have changed the settings of
the device, turn off your television and unplug the
power cord, and then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device
and lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A If the REGZA-LINK device is disconnected, the logo
will disappear after approximately one minute.