Toshiba Magnia 3030 - Manual (Page 121)

Installing and Removing Hardware
Power Supply Unit
103
Installing the EPS-R Unit (Extension: Only EPS-R model)
NOTE: The installation and replacement of an EPS-R unit requires special
technology and knowledge. If you have no experience in installing an EPS-R
unit or if the job seems difficult, consult your authorized Magnia service pro-
vider. (A service fee is charged for.)
Especially, pay careful attention when replacing the EPS-R unit while the sys-
tem is in operation.
An error in the installation procedure may damage the server or destroy and
lose important programs or data.
1 Set the switch of an EPS-R unit to be installed to OFF ( ).
Switch
2 Remove the security bracket of the EPS-R unit.
3 Turn the screw counterclockwise and remove the EPS-R unit cover from the
power slot.
4 Insert into the power slot until the eject lever is locked while pushing the
eject lever of the EPS-R unit to be installed.
Installing the EPS-R unit
5 Tighten the screw and secure.
6 Install the security bracket of the EPS-R unit.
7 Set the switch of the EPS-R unit to ON ( | ).