Toshiba Magnia 3030 - Manual (Page 90)

Installing and Removing Hardware
CPU Module 72
Replace the CPU module in the procedure below referring to “Before starting
operation” in Chapter 2.
1 If the server is running, shut it down and turn off the power.
2 For the EPS model, unplug the power cable.
3 For the EPS-R model, set the DC operate switch on the back of the server to
OFF and then unplug the power cable.
NOTE: Replacing the CPU module while the power is on may damage the
server and CPU module.
4 Remove the server panels.
See “Removing and replacing the server panels” on page 24.
CAUTION: Do not extend or replace the CPU module immediately after the
power is turned off. This may cause burns because CPU generates heat in its
periphery.
5 Remove the two screws fixing the fan duct and then remove the fan duct.
Removing the fan duct
6 Set the slider of the CPU guide rail to the unlock position.