Charging the batteries – Toshiba Qosmio G20 (PQG21) User Manual

Page 109

Advertising
background image

User’s Manual

6-7

Power

6. Be sure to monitor the remaining battery power. If the battery pack and

real time clock battery discharge completely, Standby Mode will not

function and data in memory will be lost. Also, the computer might

register an incorrect time and date. In both cases, connect the AC

adaptor to recharge the batteries.

7. Never install or remove the battery pack without first turning off the

power and disconnecting the AC adaptor. Never remove the battery

pack while the computer is in Standby Mode. Data will be lost.

Note

1. To ensure the battery pack maintains maximum capacity, operate the

computer on battery power once a week until the battery pack is fully

discharged. Refer to the section

Extending battery life

in this chapter for

procedures. If the computer is continuously operated on AC power for

an extended period, more than a week, the battery might fail to retain a

charge. It might not function efficiently over the expected life of the

battery pack and the Battery indicator might not indicate a low-battery

condition.

2. After the battery pack is charged, avoid leaving the AC adaptor

connected and the computer turned off for more than a few hours at a

time. Continuing to charge a fully-charged battery pack can damage the

battery.

Charging the batteries

The battery pack is classified as a consumable item. The operating life of

the battery pack will gradually reduce through repeated charging and

discharging. It will need to be replaced when it reaches the end of its

operating life.

You must recharge a battery pack when it becomes discharged.

Procedures

To recharge a battery pack while it is installed in the computer, connect the

AC adaptor to the DC IN 15V jack and plug the other end into a working

outlet.
The Battery indicator glows orange when the battery is being charged.

The computer enters Hibernate mode only if Hibernation is enabled in two

places: the Hibernate tab in Power Options and Setup Actions tab in

TOSHIBA Power Saver.

Use only the computer connected to an AC power source or the optional

TOSHIBA Battery charger to charge the battery pack. Never attempt to

charge the battery pack with any other charger.

Advertising