Toshiba Qosmio G20 (PQG21) - Manual (Page 120)

7-2 User’s Manual
HW Setup
Setup
This field displays BIOS Version and date.
Display
This tab lets you customize your computer’s display settings for either the
internal LCD screen or for an external monitor.
Power On Display
Lets you select the display to be used when the computer is booted - this
setting is only available with standard VGA modes and cannot be
configured through the Windows Desktop properties
Boot Priority
Your computer may be equipped with either one or two hard disk drives.
Displayed options may vary depending on the model.
Boot Priority Options
This option sets the priority for booting the computer. Within this section the
term ’HDD’ refers to the built-in hard disk drive that is defined in the HDD
Priority Option settings as being the first to be recognized. For this option
you can select from the following settings:
Auto-Selected Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD (Default).
LCD + Analog RGB Selects both the internal LCD and external
monitor for simultaneous display.
If the connected external monitor does not support the selected SVGA
mode, selecting the LCD + Analog RGB mode will not display on that
monitor.
When Windows starts up, the screen will be displayed on the external
monitor if it was connected when the notebook was previously switched off
and is still connected when the computer is switched on. Otherwise, the
screen will be displayed on the internal LCD.