Toshiba Tecra M9 - Manual (Page 110)

4-30 User’s Manual
M9
Wireless LAN
The Wireless LAN is compatible with other LAN systems based on Direct
Sequence Spread Spectrum / Orthogonal Frequency Division Multiplexing
radio technology that complies with the IEEE802.11 Wireless LAN standard
(Revision A, B, G or N Draft Ver. 1.0).
■
Frequency Channel Selection of 5GHz for IEEE 802.11a or 2.4 GHz for
802.11b/g
■
Roaming over multiple channels
■
Card power management
■
Wired Equivalent Privacy (WEP) data encryption based on an 128-bit
encryption algorithm
■
Wi-Fi Protected Access (WPA)
Setting
1. Please make sure that the Wireless Communication Switch is turned
on.
2. Click Start and then click Connect to to display Connect to a network
window.
3. Click Set up a connection or network.
4. Follow the wizard. You will need the name of the wireless network
together with security settings. Consult the documentation
accompanied with your router or ask your wireless network
administrator for the settings.
Do not install or remove a memory module while Wake-up on Wireless
LAN is enabled.
■
The Wake-up on Wireless LAN function consumes power even when
the system is off. Leave the AC adaptor connected while using this
feature.
■
The Wake-up on Wireless LAN function is effective only when it is
connected with an Access Point. This function becomes invalid when
the connection is broken.
■
The values shown above are the theoretical maximums for Wireless
LAN standards. The actual values may differ.
■
The transmission speed over the wireless LAN, and the distance over
which the wireless LAN can reach, may vary depending on surrounding
electromagnetic environment, obstacles, access point design and
configuration, client design and software/hardware configurations.
The transmission rate described is the theoretical maximum speed as
specified under the appropriate standard - the actual transmission
speed will be lower than the theoretical maximum speed.