Toshiba Tecra M9 - Manual (Page 68)

3-26 User’s Manual
M9
Hard disk drive pack
An extra hard disk drive expands the flexibility of your system and allows
you to carry your data separately without having to carry the computer.
Removing the hard disk drive pack
To remove the hard disk drive pack, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started , if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes , if required).
4. Loosen two screws securing the hard disk drive cover in place.
5. Lift the cover up and out, and remove it from the computer.
Removing the hard disk drive cover
6. Pull the hard disk drive pack up to a vertical position by holding the
plastic tab.
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.
Screws
Hard disk drive cover