Toshiba Tecra M9 - Manual (Page 90)

4-10 User’s Manual
M9
Fingerprint utility limitations
TOSHIBA does not guarantee that the fingerprint utility technology will be
completely secure or error-free, or that it will accurately screen out
unauthorized users at all times. TOSHIBA is not liable for any failure or
damage that might arise out of the use of the fingerprint software.
Changing Ultra Slim Bay modules
This section explains how to change modules in the Ultra Slim Bay. The
illustrations show replacement of the optical disc drive with the Ultra Slim
Bay HDD Adaptor. Therefore, the text refers to those modules. However,
the procedures are the same for any of the modules: DVD Super Multi drive
and HDD adaptor.
Removing a module
Remove the optical disc drive as described below.
1. You can confirm that the disks are not operating with indicators.
If all indicators are off, it means that no disks are operating currently.
2. Turn the computer upside down.
3. Remove the Ultra Slim Bay lock screw from the Lock position.
4. Set the Ultra Slim Bay lock screw in the Unlock position.
5. Slide the Ultra Slim Bay latch to the unlock position.
■
The fingerprint sensor compares and analyzes the unique
characteristics in a fingerprint. However, there may be instances where
certain users are unable to register their fingerprints due to insufficient
unique characteristics in their fingerprints.
■
The recognition success rate may differ from user to user.
To avoid injury, do not put your hand into the Ultra Slim Bay slot.
Wait for all disk indicators to go out before you turn over the computer and
do not lay the computer down gently. Shock can damage the HDD or other
components.