Sharp DK-KP85PH - Manual (Page 14)

E-5
Make sure to unplug the AC power lead before making any connections.
System connections
■ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket
and position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Installing the AM loop aerial:
<Assembling>
<Attaching to the wall>
Wall Screws (not supplied)
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
■ AC power connection
After checking all the connections have been made correctly,
plug the AC power lead of this unit into the wall socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
■ Bluetooth stand-by (Demonstration) mode
● The first time the unit is plugged in, the unit will enter
the Bluetooth stand-by (demonstration) mode. “BT
Standby” will be displayed.
● To cancel the Bluetooth stand-by (demonstration)
mode, press the BT STAND-BY button (remote control)
during power stand-by mode. The unit will enter the
low power consumption mode.
● To return to the Bluetooth stand-by (demonstration)
mode, press the BT STAND-BY button again.
● If iPod or iPhone is docked, the unit will begin charging.
“Charge Mode” will be displayed. Demonstration
mode is invalid during charge mode.
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
External FM aerial for better
reception (not supplied)
FM aerial
AM loop
aerial
Installing the supplied
FM aerial