Sharp DK-KP85PH - Manual (Page 20)

E-11
Listening to the iPod, iPhone or iPad (continued)
■ iPhone playback
● Sound will only switch from iPhone to the main
unit after authentication process is completed in
approximately 10 seconds.
● Incoming calls will pause the playback.
● Once the calls are answered, the conversation can
only be heard through the built-in iPhone speaker. Turn
on the iPhone speaker or undock the iPhone to start
conversation.
■ iPod and iPhone connection (Dock only)
Caution:
Unplug all accessories from the iPod or iPhone before
inserting it into the dock.
Note:
Docking station is for iPod touch (5th generation), iPod
nano (7th generation) and iPhone 5 connection only. Other
Apple products (iPod, iPhone and iPad) can be connected
via USB terminal.
1 Open the docking station for iPod and iPhone by
pulling up the cover.
2 Dock your iPod or iPhone into the unit.
images on page 9
iPhone (bottom)
Lightning connector
Dock for iPhone
iPhone
■ iPod or iPhone playback
1 Press the ON/STAND-BY button to turn the power
on.
2 Press the iPod button on the remote control or
FUNCTION button repeatedly on the main unit to
select iPod function.
3 Insert iPod or iPhone unit into the dock of main unit.
“Dock Ok” will appear.
4 Press the / (iPod / ) button to start playback.
BLUETOOTH
PAIRING
■ Navigating the iPod, iPhone or iPad
menus
1 Press the MENU button to view the menu on iPod,
iPhone or iPad unit. Press it again to go back to
previous menu.
2 Use the PRESET ( or ) button to select an item on
the menu and then press ENTER button.
Note:
When navigating the iPod, iPhone or iPad menu with
remote control, do not operate any of the buttons on
the iPod or iPhone unit. The volume level is adjusted by
pressing the VOLUME (+ or -) on the main unit or VOL +/-
on the remote control. Adjusting the volume on the iPod,
iPhone or iPad units give no effect.
iPod, iPhone and iPad operations:
The operations described below depend on the generation
of iPod, iPhone and iPad you are using.
System on operation:
When the main unit is powered on, the iPod, iPhone or
iPad units will automatically power on when docked or
connected in the unit.
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked
iPod, iPhone or connected iPad unit will automatically turn
to stand-by mode.