Sharp XE-A137-BK - Manual (Page 11)

9
3 Installing a Paper Roll
The register can print receipts. For the printer, you must install the paper roll provided with the register.
NOTE Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
To the printer
Incorrect
To the printer
Correct Correct Incorrect
(How to set the paper roll) (How to cut the paper end)
1. Remove the printer cover.
2. Lift up the print roller arm.
3. Set the paper correctly in the paper roll cradle as per the diagram.
NOTE
Before placing a new paper roll in the paper roll cradle, cut off
the pasted (taped) part of the paper and confirm that the cut end
of the paper is straight.
4. Feed the end of the paper along with the paper positioning guides as
per the diagram.
5. While holding down the paper, slowly close the print roller arm, and
push down the arm until you hear a click locking the arm.
NOTE
If the print roller arm is not securely locked, printing is not done
right. If this problem occurs, open the arm, and close the arm
as instructed above.
6. Cut off the excess paper and replace the printer cover.
7. Press the F key to make sure the paper end comes out of the
printer cover and clean paper appears.
NOTE
If the paper end does not come out, open the printer cover,
and pass the paper end between the paper cutter and the
paper guide of the printer cover, and replace the printer
cover.
Paper positioning guides
Print roller arm