Sharp XE-A137-BK - Manual (Page 77)

75
■
Data saving
The sales data, EJ data or programming data can be saved to the SD card.
s A @ s *Job no.
*Job no. Saving data
141 All programming data
144 All RAM data
650 Sales data
750 EJ data (save and clear)
■
Data loading
The sales data, EJ data or programming data can be saved to the SD card.
s A @ s
*Job no.
*Job no. Loading data
147 All programming data
148 All RAM data
NOTE
The loading operation must be circumspect in execution, the data (#147: for all programming data,
#148: for the sales data and all programming data) will be recovered with the back-up data.
■
Error message table of the SD card function
Error code Error state and action
01
No SD memory card is found. Insert an SD memory card into the SD card slot or reinsert it
correctly.
02
The write-protect switch on the SD memory card is in the “PROTECTED” position. Set the
switch on the “NOT PROTECTED” position.
03
The SD memory card is full. Delete unnecessary data from the card on a PC or replace the
card with a new one. When using a new SD memory card, be sure to format it in advance.
05
The data stored in the SD memory card is incorrect. Write correct data into the SD memory
card on a PC.
09 The user folder is not found. (SHARP/ECRXXX14/user folder name)
10 Over limitation of data records (Over max. record in sales or EJ data.)
99
An error other than the above mentioned has occurred while the SD memory card is
accessed. Perform the interrupted operation again from the beginning.