Sharp XE-A137-BK - Manual (Page 72)

70
EJ REPORT READING AND RESETTING
The cash register provides an electronic journal (EJ) function. This function is intended to record the journal data
in a memory instead of journal paper, and print the data as an EJ report. The register records the journal data in
REG,
, X/Flash, and Z/PGM modes. By default, a maximum of 3000 lines are stored in the memory. For
details of EJ programming, please refer to “Other programming (Job code 68)” on page 58.
■
Printing journal data on the way of a transaction (temporary EJ printing)
You can print journal data of a current transaction recorded in EJ memory by pressing the R key during the
transaction.
NOTE This function is valid when the receipt ON/OFF function is set to OFF. For changing the setting, refer to
“Additional Information for BASIC SALES ENTRY” on page 29.
• Sample report
■
Reading and resetting the electronic journal data (Issuing EJ report)
You can read the journal data stored in the EJ memory in the journal format by executing the following procedure
in the X/Flash or Z/PGM mode.
To reset all of the data: (Z/PGM mode)
A
To read the last 10 records: (X/Flash mode)
To read all of the data: (X/Flash mode)
A @
@
A @
700
700
710
• Sample EJ report
Header
information
print NOTE
• By programming, you can also issue an EJ
Z report without printing the journal data on
it. Refer to “Other programming” (Job code
68) on page 58 for the programming.
• To stop reading or resetting the data, press
the E key. The data will not be erased
when resetting.
• On the EJ memory, a maximum of 3000
lines of data can be stored. When executing
all data reading, all of the data stored in the
EJ memory will be printed.