Philips AVENT Esterilizador a vapor eléctrico 4 en 1 - Manual (Page 10)

1 Pour 80ml/2.7oz of white vinegar (5% acetic acid) and 20ml/0.7oz of water into the water
reservoir.
2 Leave the solution in the water reservoir until the scale has resolved.
3 Empty the water reservoir, thoroughly rinse it and wipe the base with a damp cloth.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 12).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country. You find its phone
number in the worldwide guarantee leaflet. If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, contact the Consumer Care Centre in your country.
Question Answer
Why does water flow out of
the steriliser?
You may have poured too much water into the steriliser. Do
not pour more than 100ml water in the water reservoir.
Why are there white spots in
the water reservoir, the baskets
or the lid?
Scale build-up is normal and occurs more quickly in hard water
areas. Descale the appliance regularly (see chapter ‘Descaling’).
Why does a lot of steam
escape from under the lid?
Check if the lid has been placed on the basket properly.
Why does the sterilisation
process take so long?
You may have poured too much water into the steriliser (see
chapter ‘Using the appliance’). The number of items placed in
the baskets and the number of baskets used determine the
actual sterilisation time.
Why is the sterilisation process
so short?
You may have poured too little water into the steriliser (see
chapter ‘Using the appliance’).
Why does the appliance start
to heat up immediately when I
plug it in?
You have pressed the power-on button before you plugged in
the appliance. When you press the power-on button before
you put the plug in the wall socket, the steriliser starts
operating immediately when you plug it in.
SCF285/SCF284: Why can’t I
restart the appliance.
The appliance does not work for 10 minutes after a sterilising
cycle, it needs to cool down first. Wait for 10 minutes, before
you switch on the appliance again.
SCF287/SCF286: Why doesn’t
the ready light go out, when I
restart the appliance?
The appliance does not work for 10 minutes after a sterilising
cycle, it needs to cool down first. Wait for 10 minutes, before
you switch on the appliance again.
EngliSh 10