Brother LK3-B448E - Manual (Page 67)

LK3-B448E MARK II /BA-16
13. Using the cycle sewing function
60
1. When “c1-1” is flashing in the display window
!0
, press the foot switch to the second step.
2. Start sewing.
3. “c1-1”, “c1-2”, “c1-3” are sewn in order for each article, and when the last-recorded pattern has been sewn, the
display returns to “c1-1”.
* If you press one of the DISPLAY SET switches !1 when “c1-*” is displayed, you can return to the previous stitch pattern or skip a stitch
pattern.
* If you press the SELECT switch e when “c1-*” is displayed, you can check the contents of the recorded user program.
Using a cycle sewing program
Clearing a cycle sewing program
1. Switch the machine to recording mode by the procedure in step 3. of recording a user program.
2. Use one of the P* switches (user program switches) to specify which cycle sewing program to clear.
* Press the P1 switch o if you would like to clear cycle sewing program No. 1. (“Pc 1” will be displayed.)
3. Press the RESET switch
!2
.
* The recorded contents of the specified cycle sewing program will then be cleared.
* If you press and hold the RESET switch !2 until after the buzzer has sounded twice, all cycle sewing programs will be cleared.
NOTE:
If you clear a user program after any cycle sewing programs have been recorded, all recorded cycle sewing programs will also
be cleared.