Philips AVENT Vigilabebés con vídeo digital - Manual (Page 7)

Storage precautions
- Use and store the baby monitor between 10°C (50°F) and 40°C (104°F).
- Do not expose the baby unit and parent unit to extreme cold or heat
or to direct sunlight.
- Do not put the baby unit and the parent unit close to a heating source.
replacement
- If you need to replace the battery and the adapter, please refer to the
user manual and contact the Philips Customer Care Center.
Supplied AC/DC Adapter for parent unit. Input: 100-240V AC, Output:
5 V DC, 1 A. Model No.: S006MB0500100 (UK plug); S006MV0500100
(EU plug); S006MU0500100 (US plug); S006MS0500100 (AU plug);
S006MA0500100 (AR plug); S006MD0500100 (Brazil plug).
Supplied AD/DC Adapter for baby unit. Input: 100-240V AC, Output:
6 V DC, 500 mA; Model No.: SSW-1920UK-2 (UK plug); SSW-1920EU-2
(EU plug); SSW-1920US-2 (US plug); SSW-1920AU-2 (AU plug);
SSW-1920AR-2 (AR plug);SSW-1920BR-2 (Brazil plug).
- For the baby unit, only use 1.5V AAA alkaline batteries
(batteries not supplied).
- For the parent unit, only use the Li-Ion polymer rechargeable battery
Model N-S150, 3.7V, 1100mAh as supplied with the appliance.
- If you need to replace the battery and the adapter, please contact the
Philips Customer Care Center.
general
- The operating range of the baby monitor is 150 meters/490 feet in
open air. Depending on the surroundings and other disturbing factors,
this range may be smaller.
- If you have any combination of cordless phones, wireless video, Wi-Fi
networks, microwave or Bluetooth on 2.4Ghz, connection problems may
occur. The connection between the parent unit and the baby unit could
be lost for some seconds or may cause interference with other devices.
- We advise you to use the parent unit connected to the mains to
save energy. The baby video monitor consumes more energy than a
standard baby monitor (without video).
Compliance information
- This device complies with Part 15 of the FCC Rules and Industry
Canada License-exempt RSS standard. Operation is subject to the
following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
radio interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-
003 of Industry Canada. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
EngliSh 7