Barco ULTRA REALITY 7000 - Manual (Page 28)

4. Getting started
COLOR PHASE
SHARPN TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
2 1
4 3
5 6
8
0 9
7
CONTRAST
Stand-by key
9
7
5
3
1
0
8
6
4
2
F1
F2
F3
ENTER
MENU BACK
LENS
ZOOM
LENS
SHIFT
LENS
FOCUS VOL
CONTR
BRIGHTN
COLOR
TINT
DIGI
ZOOM
PHASE
PAUSE PIP LOGO
Image 4-3
It may take about 60 seconds before image projection, i.e. no projection until the completion of several oper-
ations (software initialization,...).
4.4 Lamp runtime
Lamp runtime indication while running
When the total runtime of the lamp is 970 hours or more, a warning message will be displayed.
This warning message will be repeated at the next start up. Press BACK or MENU to remove the message.
The total lifetime of the lamp for a safe operation is 1000 hours max, do not use it longer. Always replace with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.
At the end of the lifetime of the lamp (1000 hours) the projector generates an alert message.
A countdown time of 4 minutes is triggered before the projector is shut down (standby).
If the lamp runtime has not been reset, the alert message will reappear at the next start up (with again 4 minutes countdown time).
This alert message can be escaped with MENU or BACK, but the countdown continues.
Contact a qualified Barco technician for lamp replacement.
Using a lamp for more than its recommended life time is dangerous as the lamp could explode.
24 R5976455 BARCO ULTRA REALITY 7000 30062003