An image files contains the main characteristics of a source (number of active lines,...). The projector’s memory contains a list of
files corresponding to the most common sources, these are the standard files (file extension = *.s). When a new source corresponds
to one of these files, a custom file (file extension =*.C) is created and saved for future use.

When there is a little difference, the file can also be loaded and then edited until the source specs are reached.

The AutoImage function creates automatically the best suited image file (custom file) for a new source. Au-
toImage is used when:

- a new source is detected : AutoImage creates a new custom file which can always be edited if necessary.

- the AutoImage button on the RCU is pressed

AutoImage works only in full screen mode

If the AutoImage function does not succeed in finding a file and no file is loaded (load list is empty), which
means that the source is not displayed, then use the copy function,

10.1 Load file

How to load a file ?

1. Press MENU to activate the Toolbar

2. Press → to select the Image files item

3. Press ↓ to Pull down the Image files menu

4. Use ↑ or ↓ to select Load (image 10-1)

5. Press ENTER

A dialogbox is displayed (image 10-2)

6. Use ↑ or ↓ to select the desired file

Tip:

For more info about the available image files and the specifications, see appendix B

7. Press ENTER

The file is loaded and the image is adapted.

Image 10-1

R5976455 BARCO ULTRA REALITY 7000 30062003

Advertising