Philips PerfectDraft Tireuse à bière domestique - Manual (Page 11)

4 Push down the blue locking levers until they are in horizontal
position.
If you are unable to put the locking levers in horizontal position, you have
not put the keg into the appliance in the right position. Take out the keg
and follow steps 1 to 3 again.
, After you have installed the keg (even the first time), the pump runs
for a few seconds.
5 Close the doors.
cooling
After you have installed the keg, the appliance automatically starts to cool
the keg.
Note: At an ambient temperature of 23°C, chilling an uncooled keg takes
12-15 hours.
Tip:If you want to pour beer shortly after placing the keg in the appliance,
prechill the keg in upright position in the fridge for a while before you install it.
For more tips, see chapter ‘Troubleshooting’.
1 Wait until the beer has reached a drinking temperature of 4°C or
below.
, The temperature is shown on the display in green (see section ‘LCD
display’ in this chapter).
lcD display
, The display shows the temperature of the beer, the beer level inside
the keg and the freshness of the beer.
temperature indication
Wait until the temperature of the keg has dropped below 4°C before you
start to pour beer. The ideal drinking temperature is 3°C.
The colour of the temperature displayed tells you if the beer has reached
the right drinking temperature.
- Red = the beer temperature is not yet ideal for consumption (above
4°C). The beer head may be too large.
- Green = the beer has reached the right temperature (4°C or below)
for consumption.
level indication
The yellow-orange level indication on the display shows the amount of
beer left in the keg in eight steps.
EnglisH 11
4222.001.9361.3.indd 11 08-02-10 10:52