Philips Robot cuiseur vapeur et mixeur Philips AVENT - Manual (Page 15)

5 Place the empty jar (without any food inside) fully assembled with blade unit and lid on the
motor unit in steaming position (i.e. with the lid pointing downwards).
6 Turn the control knob to steaming position.
, The steaming light lights up orange to indicate that the appliance is steaming.
7 Switch off the appliance after 5-6 min of steaming and unplug it.
8 Pour the used solution of citric acid (or vinegar) and water out of the water tank. (Fig. 24)
9 Rinse the water tank and the jar thoroughly with fresh water several times.
10 Fill the tank with 200ml water and let the appliance complete a steaming process of
20 minutes with the empty jar before you use the appliance with food again.
11 Leave the lid of the filling opening open to prevent bacterial growth.
Environment
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 25).
Storage
1 Empty the water tank before you store the appliance (Fig. 24).
2 Make sure all parts are clean and dry before you store the appliance (see chapter ‘Cleaning’).
3 Store the appliance with the blade unit in the jar to prevent damage.
4 Do not place the lid on the jar and leave the lid of the filling opening open to avoid bacterial
growth.
Guarantee and support
If you need information or support, please visit www.philips.com/support or read the separate
worldwide guarantee leaflet.
Technical specifications
- Voltage/wattage: see type plate on the bottom of the appliance.
- Maximum capacity of water tank: 200ml.
- Maximum capacity of jar, liquids: 450ml.
- Protection: temperature-controlled heating system and safety lock.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
ENGLISH 15