Bradley Smoker EXPRESS SS-2/AST/JUV - Manual (Page 7)

7
Express® Lavatory System SS-Series
Installation - Obsolete SS-2/AST/STD, SS-2/AST/JUV
Bradley Corporation • 215-1244 Rev. D; EN 08-805 4/24/08
Installation Instructions continue . . .
Installation Instructions continued . . .
Step 2: Mounting frame to wall
1. Remove the eight Torx-head screws
securing the panel to the frame, and
remove the panel (see Figure 3).
Note: Scuff panel does not need to be
removed.
2. Position the frame against the wall,
ensuring that it is level. If necessary,
insert shims under the frame until level.
Note: When mounted, the Standard and
Juvenile Height frames should rest on the
floor.
IMPORTANT: Anchoring the frame
to a wall that is not flat may
cause the frame to bend. If nec-
essary, install shims to compen-
sate for any wall distortion.
3. Ensure that the back of the frame is flat against the wall. If wall is not flat, insert shims
behind the frame to ensure that it will not bend when anchored.
4. Once you have positioned the frame such that it is level and resting on the floor and flat
against the wall or shimmed, use the 3/8" bolts and washers to mount the frame to the wall
(see Figure 4).
Figure 4
(4) 3/8" BOLT
AND WASHER
FRAME
Figure 3
PANEL
FRAME
(8) TORX-HEAD
SCREW
Figure 2
1-1/2" NPT DRAIN
STUB-OUT
1/2" NPT HOT AND
COLD SUPPLIES OR
TEMPERED SUPPLY
STUB-OUTS
SCUFF PANEL
(do not remove)
SCUFF PANEL
(do not remove)