Bradley Smoker EXPRESS SS-2/AST/JUV - Manual (Page 8)

8
Express® Lavatory System SS-Series
SS-2/AST/STD, SS-2/AST/JUV
Installation - Obsolete
4/24/08 Bradley Corporation • 215-1244 Rev. D; EN 08-805
Installation Instructions continued . . .
Step 3: Installing bowl assembly
IMPORTANT: Moving and positioning the bowl will require more than one person.
Note: Refer to Figure 5 below when installing the bowl assembly.
1. With someone to assist you, place the bowl assembly squarely onto the frame.
2. Attach the front of the bowl assembly to the frame using the two 1/4"-20 x 3/8" pan-head
screws and washers. Do not tighten screws at this time.
IMPORTANT: When bolting the bowl assembly to the frame and wall, do not overtight-
en bolts. Overtightening bolts can damage the Terreon® material.
3. After the bowl assembly is attached to the frame, use two 3/8" bolts and washers (supplied
by the installer) to bolt the bowl to the wall anchors.
4. Tighten the screws installed in procedure #2 above to secure the bowl assembly to the frame.
Do not overtighten.
Installation Instructions continue . . .
Figure 5
3/8" BOLT
AND
WASHER
BOWL ASSEMBLY
BACK VIEW
3/8" BOLT
AND
WASHER
1/4"-20 X 3/8"
PAN HEAD
SCREWS AND
WASHERS