BlueAnt Bluetooth SUPERTOOTH II - Manual (Page 18)

IMATE POCKET PC / JAM
Note: Please make sure you have the latest firmware upgrade for your Phone. Go to the
support section of the relevant site to check you have the latest version. You will need to
register your device to download updates.
For Imate go to
www.clubimate.com
a. ACTIVATING THE BLUETOOTH
You must activate the Bluetooth feature of your Imate to establish a Bluetooth connection
between your Pocket PC device and other Bluetooth devices.
1. Tap . Scroll down to Settings. Tap Connections. Tap Bluetooth.
2. Select On and tap ok.
3. Tap 9 to exit.
b. PAIRING TO THE CELLULAR PHONE
1. Bring your Imate to within about 20 cm from the Handsfree Kit.
2. The Supertooth II is initially off. Turn it on by flipping up the Swivel Arm to the 55º
position. The Bluetooth Indicator will glow (blue blink).
3. Simultaneously press the Reject Button and the Pick-Up/Hang-Up Button for about 10
seconds. A distinctive tone will be heard and the Bluetooth Indicator LED will change
from blinking blue to alternate blinking red and blue. SuperTooth II is now in Handsfree
Pairing Mode.
4. Press the Pick-Up/Hang-Up Button once again for a short time to access Headset
Pairing Mode. The Supertooth is now in the correct pairing mode for the Imate .
(most important)
5. Tap . Scroll down to Settings. Tap Connections tab. Tap Bluetooth.
6. Tap
Bonded Devices tab. Tap New.
Your device now searches for Bluetooth devices and displays them in the list.
7. Tap the name of the device that you want to bond with your PC phone, and then tap
Next.
8. Enter “0000” as the Device PIN and then tap Next.
9. Tap Finish. (Note: In Name, you may or may not edit the name of your bonded device).
10. For the question, “This Bluetooth device supports headset profile, would you like to set it
as your Blue tooth headset?”, tap Yes.
11. Tap ok, and then 9 to exit.
The Handsfree Kit is paired with your Imate. An enabled Bluetooth icon will be seen on screen
indicating that the Handsfree Kit is linked with the Imate.
c. ANSWERING/RECEIVING A CALL
When the phone is receiving a call, two dissimilar ring tones will be heard from the phone and
then from the Handsfree Kit.
1. When answering is done on the Handsfree Kit (that is, pressing Send once), audio will
be heard on it.
2. When answering is done on the phone, ongoing call will be heard on the phone (not on
the Handsfree Kit). But if you wish to hear and transfer the audio to the Handsfree Kit,
just press the Send button once on the Supertooth.
3. To terminate the call, press down the Pick-Up/Hang-Up Button.
18