BlueAnt Bluetooth SUPERTOOTH II - Manual (Page 52)

The most direct method is by using the Phone keypad.
4.
Tap the number on the phone’s keypad, and then press the DIAL key on the
phone.
Note: Audio will be heard directly on the Supertooth. At times, for first time dialing, audio
will be heard on the phone and not immediately on the Supertooth. If this is the case you
have to press once on the Pick-Up/Hang-Up Button to transfer the audio to the Kit.
5.
To terminate the call, press down the Hang-Up Button on the Supertooth or press
End on the phone
Voice Dialing
Voice Dialling is not included in the Treo but is available as a software add-on.
Set up voice commands for contact’s as per the Palm Voice Dial user manual.
To activate voice dialing…
1. Press the Pick-Up/Hang-Up button once on the Supertooth, or press the Multi-Function
button on the phone.
2. When prompted by a beep, say the name you wish to call.
Redial
Calls the last number dialed from the phone.
1. Press and hold for 3 seconds the Pick-Up/Hang-Up key on the Supertooth.
e. AUDIO TRANSFER DURING A CALL
Kit to Phone
Flip down the Swivel Arm (1) to 0º position (or turn-off the unit). This will automatically
transfer the audio from the kit to the phone.
Phone to Kit
Flip the Swivel Arm up from 0º to 55ºor 210º position (Turn-On the Kit). Then
press shortly the Pick-Up/Hang-Up Button(7). The audio will be transferred
from the phone to the kit.”
f.
REJECTING A CALL
Rejecting a call can be done from the Phone by selecting IGNORE or from the Supertooth by
pressing the Reject Button
Note: It is recommended to create a phone profile to use with the Supertooth. Configure phone
volume and ring settings to suit your cars environment.
g. RECONNECTING SUPERTOOTH
After turning the SuperTooth back on, Press the Pick-Up/Hang-Up key on
the SuperTooth once to Reconnect.
52