O2 xphone2 – BlueAnt Bluetooth SUPERTOOTH II User Manual
Page 45
O2 XPHONE2
Note: Please make sure you have the latest firmware upgrade for your phone. Go to the
support section of the following website to check you have the latest version.
You will need to register your device to download updates.
For Xphone2 go
a.
ACTIVATING THE BLUETOOTH
You must activate the Bluetooth feature of your phone to establish a Bluetooth connection
between your Pocket PC device and other Bluetooth devices.
1. Select Start
. Select Settings. Select Bluetooth. Select Bluetooth
2. Select On and tap ok.
b.
PAIRING TO THE CELLULAR PHONE (not possible while charging)
1.
Bring your phone to within about 20 cm from the Supertooth.
2.
The Supertooth II is initially off. Turn it on by flipping up the Swivel Arm to the 55º
position. The Bluetooth Indicator will glow (blue blink).
3. Simultaneously
press
the
Reject Button and the Pick-Up/Hang-Up Button for about 10
seconds. A distinctive tone will be heard and the Bluetooth Indicator LED will change
from blinking blue to alternate blinking red and blue. SuperTooth II is now in Handsfree
Pairing Mode.
4.
On your phone Select Start
. Select Settings. Select Bluetooth. Select Bluetooth.
5. Select
Menu…Select Devices… Select Menu…Select New.
Your phone now searches for Bluetooth devices and will display them in the list.
6.
Scroll to the name of the device, Supertooth, and then press Select.
7.
Enter “0000” as the PassKey and then tap Done.
8.
Enter a Display Name and Press Done. Note: In Name, you may or may not edit the
name of your bonded device).
9.
For the question, “Would you like to designate Supertooth as a handsfree device?”,
Select Yes.
The Handsfree Kit is paired with your Xphone2. An enabled Bluetooth icon will be seen on
screen indicating that the Supertooth is linked.
c.
ANSWERING/RECEIVING A CALL
When the phone is receiving a call, two dissimilar ring tones will be heard from the phone and
then from the Handsfree Kit.
1.
When answering is done on the Supertooth (that is, pressing Pick-Up/Hang-Up
once), audio will be heard on it.
2.
When answering is done on the phone, ongoing call will be heard on the phone
(not on the Supertooth). But if you wish to hear and transfer the audio to the
Handsfree Kit, just press the Pick-Up/Hang-Up button once on the Supertooth.
3.
To terminate the call, press down the Pick-Up/Hang-Up Button.
45