02 xphone – BlueAnt Bluetooth SUPERTOOTH II User Manual
Page 49
02 XPHONE
Note: Please make sure you have the latest firmware upgrade for your Phone. Go to the
support section of the relevant site to check you have the latest version. You will need to
register your device to download updates.
For Xphone go to
a.
ACTIVATING THE BLUETOOTH
You must activate the Bluetooth feature of your Xphone to establish a Bluetooth connection
between your device and other Bluetooth devices.
1. Tap
. Scroll down and Tap Settings. Tap Bluetooth.
2. Scroll to On and Tap Done.
b.
PAIRING TO THE CELLULAR PHONE
1.
Bring your Xphone to within about 20 cm from the SuperTooth.
2.
The Supertooth II is initially off. Turn it on by flipping up the Swivel Arm to the 55º
position. The Bluetooth Indicator will glow (blue blink).
3. Simultaneously
press
the
Reject Button and the Pick-Up/Hang-Up Button for about 10
seconds. A tone will be heard and the Bluetooth Indicator LED
will change from blinking blue to alternate blinking red and blue.
SuperTooth II is now in Handsfree Pairing Mode.
4.
Press the Pick-Up/Hang-Up Button once again for a short time to access Headset
Pairing Mode. The SuperTooth is now in pairing mode for Xphone (most
important)
5. Tap . Scroll down and Tap Settings. Tap Bluetooth and then Menu.
6. Tap
Bonded Devices tab. Tap Menu and then New. (Xphone will now search for devices)
7.
Scroll to SuperTooth and select Add.
8.
Enter “0000” as the Device PIN and then tap Done.
9.
For the question, “This Bluetooth device supports headset profile, would you like to set it
as your Bluetooth headset?”, tap Yes.
10. Tap
ok,
and then exit.
The Handsfree Kit is paired with your Xphone.
c. ANSWERING/RECEIVING
A
CALL
When the phone is receiving a call, two dissimilar ring tones will be heard from the phone and
then from the SuperTooth.
1.
When answering is done on the SuperTooth (that is, pressing Send once), audio will be
heard on it.
2.
When answering is done on the phone, ongoing call will be heard on the phone (not on
the SuperTooth). But if you wish to hear and transfer the audio to the Handsfree Kit, just
press the Send button once on the SuperTooth.
3.
To terminate the call, press down the Pick-Up/Hang-Up Button.
d.
MAKING A CALL with the Handsfree Kit on
Normal dialing
With your Xphone you can make a call using different methods. Please refer to your PC
Phone’s User Guide.
The most direct method is by using the Phone keypad.
49