Barco CINE7 R9010050 - Manual (Page 94)

9. Service Mode
How to add the Barco Logo
1. Push the cursor key
↑
or
↓
to highlight Barco Logo. (menu 9-19)
2. Press ENTER to select.
The BARCO logo menu will be displayed on the screen. (menu 9-20)
Within this menu, four toggle settings are available.
Mode[ON/OFF] Select mode and toggle with ENTER between ON and OFF
ON : BARCO logo will be displayed on the screen when leaving the adjustment mode. To position
the logo on the screen, push the cursor key up, down, to the left or to the right until the desired
position is reached.
OFF : No BARCO logo displayed on the screen when leaving the adjustment mode.
Size[ON/OFF] Select size and toggle with ENTER between SMALL and LARGE
SMALL : Small BARCO logo will be displayed if mode is on.
LARGE : Large (double size) BARCO logo will be displayed if mode is on.
Background[ON/OFF] Select background and toggle with ENTER between ON and OFF
ON : BARCO logo will be displayed on a black background. BARCO
OFF : BARCO logo will be displayed without any background. BARCO
Orbiting[ON/OFF] Select orbiting and toggle with ENTER between ON and OFF
ON : the BARCO logo will orbit around its axis.
OFF : no orbit of the BARCO logo.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-19
BARCO LOGO
MODE : ON
SIZE : SMALL
BACKGROUND : ON
ORBITTING : ON
You can move the logo
on the screen using
the arrow keys.
WARNING : continuous
use of the BARCO logo
damages the RED CRT !
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-20
9.4 Memory Management
Overview
• Starting Up Memory Management
• Copy a Block
• Delete a Block
• Delete All Blocks
• All Settings to Midposition
• R & B Convergence to Midposition
• Green Convergence to Midposition
90 R5976584 BARCO CINE7 26022003