Barco R59770449/01 - Manual (Page 26)

3. Preferences
Image 3-11
Logging and debugging preferences
Logging level
Click on the slider bar to set the desired logging level.
The following levels are possible:
•
Debug
• Info
• Error
• Warning
• Fatal
Message to log file
The logging about the behavior of the program can be logged in a file. Each time the program is started
a new log file is created. The file is saved in a subdirectory log of the DC Toolset install directory. The file
name contains the date and the sequence of start up at that date.
The logging level can be set to limit the number of data. By default, Info level is setup. Other levels are
Debug, Warning, Error and Fatal.
Check the check box in front of Write log messages to file if you want to activate the logging. This is a
preferred setting.
The period a logging must be saved on disk can be set. Default set to 20 days. All logging older than 20
days will be removed.
When the period is set to “0”, only the last created logging will remain on the disk.
To clear the complete logging directory, click once on Clear all.
3.7 Workspace selection
Start up
1. Click on Workspace selection. (image 3-12)
The workspace selection dialog box opens.
2. To change to another workspace, click on the drop down box and select the desired workspace. (im-
age 3-13)
22 R59770449 DC TOOLSET 15/12/2009