Barco R59770449/01 - Manual (Page 75)

A. Recovery a projector with special plug-in
If the code is entered correctly, the Projector Toolset Settings dialog opens otherwise retry this step.
2. Disable Check device type before update (both items must be disabled). (image A-5)
3. Click OK to close the dialog.
4. Click Update now.
An update dialog window opens with the message that the projector is from an unknown type. (im-
age A-6)
5. Click on the combo box and select the correct projector type.
Click OK to continue.
The Update package selection window opens. (image A-7)
6. Select the correct package and click Next.
Note: Using a wrong package can damage the projector completely.
Version information is collected. This operation can take while. (image A-8)
7. If something is checked, uncheck these items (double click to uncheck) and click on Next stage.
8. Uncheck all items by double clicking on the checked items except for item dp80. Click Next. (image A-9)
An overview is given of the software to be installed.
9. Click Install.
The selected software will be installed on the projector. This can take a few minutes. Wait until it is
finished.
When finished, a reboot message is displayed. Reboot the projector.
10.When the projector is rebooted, click OK. The installation continues and when Installation OK is dis-
played.
Continue now with the update of all other software.
Image A-5
Projector Toolset settings
R59770449 DC TOOLSET 15/12/2009 71