Barco R59770449/01 - Manual (Page 30)

4. Configurator
4.3 Create a new configuration
Steps to be taken
1. Click File on the menu and select New → New configuration (a). (image 4-2)
Or,
press Ctrl + N.
The New configuration dialog box opens (b).
2. Fill out a name for the new configuration next to Configuration name. The default name will be Config-
uration_’digit’ (c).
Note: Only the characters a to z, A to Z, 1 to 9 and (, ), _, -, @ or allowed in a name.
When it is the first configuration for this workspace, only the option Create by adding projectors is avail-
able.
When there are already configuration available, the option Based on available configuration becomes
available
3. Check the radio button of your choice (d).
4. When Based on available configuration is checked, click on the combo box and select the configuration
on which the new configuration must be based on (e).
5. Click OK to create the new configuration (f).
Image 4-2
Create new configuration
4.4 Add device to a configuration via scanning
What can be done ?
The network is scanned for possible devices which can be added to the configuration. The overview list
shows all possible devices on the network and not only the devices with an installed plug-in. Even the
devices which are already in the configuration are in the list.
Multiple devices can be added at the same time. It is not possible to add a device twice or to add a device
for a non installed plug-in.
26 R59770449 DC TOOLSET 15/12/2009