Ransburg DynaFlow User Manual - Manual (Page 45)

LN-9400-00.9
Operational Parameters
Flow Rate
• Indicates total flow rate through a GUN.
• If in 2K, sums the total of each CHANNEL
attached to the GUN.
• If in 1K, simply indicates the CHANNEL
flow rate.
GUN Status
Indicates the current status of the GUN. This can
be one of the following:
GUN Active (in run mode)
GUN Halted
CLEAN mode active
LOAD mode active
CALIBRATION mode active
GUN faulted
Transparent mode active
Analog Hold mode active
Pot Life Time Exceeded
JOB Queue
Stores the next JOB to be run. A RUN command
following a HALT will load the next JOB # from
the Queue. If more than one JOB # is toggled into
the Queue before the next RUN command, then
the newest JOB # is placed into the Queue and
the previous JOB # is lost.
Calculated Pulses/Liter
This is the new Pulses/Liter value based on the
Number of Pulses received from the flow meter
during calibration and either the Measured Volume,
or the Measured Weight and Specific Gravity. The
operator may override the Calculated Pulses/Liter
value by entering a Calculated Pulses/Liter value.
Current Pulses/Liter
Displays the current Pulses/Liter value used by
the Channel Module during calibration. If this
value is inaccurate at the time, which is why cali-
bration is being performed, the Actual Flow Rate
and Calculated Beaker Volume values will also
be inaccurate.
DynaFlow TM User Manual - Operation
41