BT Paragon 200 - Manual (Page 10)

7
Paragon 200 - Edition 4.3 – 26th Sept ’00
7
Fit plinth for desk mounting and
track cables
SETTING
UP
If you use your Paragon 200 as a desk phone
you will need to fit the stand on to the base.
Ensure all the cables on the underside of
the base are in their respective channels.
Proceed by holding the stand as shown in the
illustration, ensuring the two arrows are facing
each other.
Now lower the stand so that the two lugs
nearest to you, fit into the corresponding holes
on base, as shown.
Push and squeeze until the stand clicks into
place from front and back as shown in the inset.
ARROWS
The Paragon 200 automatically goes through a
start-up process during which the display shows
init
, and both the secrecy LED and message
indicator flash once.
On completion the unit will beep and the display
will show the number of messages.
Your Paragon 200 is now ready to record
messages.
6
Plug the mains adaptor into the wall
socket and switch on
Please Note
Your machine automatically adds the time and
day to each incoming message recorded.