BT Paragon 200 - Manual (Page 15)

Selecting the answering
machine mode To use the pre-recorded
outgoing message
When your answering machine is switched on,
the pre-recorded message will automatically
greet callers with:
“Hello, your call cannot be taken at the moment,
so please leave your message after the tone.”
Callers can skip this message by pressing the #
button and record their message after the tone.
The pre-recorded message remains in the memory
and you can always choose to use it again.
Default for Answer Only Outgoing Message.
”Hello, your call cannot be taken and you cannot
leave a message. So please call back later.“
12
Paragon 200 - Edition 4.3 – 26th Sept ’00
Using the answering machine
To switch the answering machine on, off
and to Answer Only
To listen to and switch between the male
and female pre-recorded Out Going
Message (OGM)
To set to any of the above settings press and
release the Answer On/Off button until the
prompt announces your required setting.
NB: You will not lose messages when switching
between these settings.
Press buttons in the order shown
Press and release until the display
shows OGM.
Default is played.
Press either button during playback to
switch between a male or female voice
for your OGM message.
Sel
memo
Play
Setting Description Display
On Receives incoming Number of
calls and records messages eg.
messages. 00 or 01 etc.
Off Does not record Screen is
messages. blank
Answer Only Will play your AO
outgoing message
but will not record
messages.
ANS
WER
MA
CHINE