Philips SE8881B-22 - Manual (Page 60)

60
Make sure that the handset ringtone is turned
on.
The caller ID does not display.
• The service is not activated. Check with
your service provider.
• The caller’s information is withheld or
unavailable.
Note
• If the above solutions do not help, disconnect the
power supply from both the handset and base station.
Try again after 1 minute.
There is unknown text/symbols displayed on
the phonebook list.
Normally, SE888 can recognize the text/symbols
specified in the section “Text and number”. If
you still find unknown text/symbols, you are
recommended to change them to English text.
If I fail to register the additional handsets to
the base station, what do I do?
Your base memory is full. Unregister the unused
handsets and try again.
No dialing tone
• Check your phone connections.
• The handset is out of range. Move it closer
to the base station.
I cannot change the settings of my voice mail.
The voice mail service is managed by your
service provider but not the phone itself.
Contact your service provider to change the
settings.
The handset on the charger does not charge.
• Make sure that the batteries are inserted
correctly.
• Make sure that the handset is placed
properly on the charger. The battery icon
animates when charging.
• Make sure that the docking tone setting
is turned on. When the handset is placed
correctly on the charger, you can hear a
docking tone.
• The charging contacts are dirty. Disconnect
the power supply first and clean the
contacts with a damp cloth.
• Batteries are defective. Purchase new ones
from your dealer.
No display
• Make sure that the batteries are charged.
• Make sure that there is power and the
phone is connected.
Bad audio (crackles, echo, etc.)
• The handset is nearly out of range. Move it
closer to the base station.
• The phone receives interference from the
nearby electrical appliances. Move the base
station away from them.
• The phone is at a location with thick walls.
Move the base away from them.
The handset does not ring.
EN