Philips SCD520-00 User Manual
Page 19
Adjusting microphone sensitivity
You can set the microphone sensitivity of the baby unit to the desired
level. You can only change the microphone sensitivity when a connection
between the baby unit and the parent unit has been established, i.e. when
the LINK light on the parent unit lights up green continuously.
1
Select ‘Sensitivity’ with the + and - buttons.
2
Press the OK button to confi rm.
3
Select the desired microphone sensitivity level for the baby unit
with the + and - buttons.
k = minimum sensitivity level
l
= maximum sensitivity level
4
Press the OK button to confi rm.
The message ‘Saved’ appears on the display.
Note: When the microphone sensitivity of the baby unit is set to a high level, it
picks up more sounds and therefore transmits more often. As a result, the units
consume more power.
Sound alert on/off
This feature allows you to monitor your baby silently. It enables you to
switch off the volume on your parent unit and still be alerted if your baby
cries.
If the sound alert is switched on, the parent unit beeps as soon as the
fourth sound level light lights up blue while the volume is switched off. In
addition, the backlight of the parent unit display goes on and the sound
alert symbol ( R ) fl ashes on the display.
1
Select ‘Sound Alert’ with the + and - buttons.
2
Press the OK button to confi rm.
3
If the alert is off, the display shows ‘On?’. Press the OK button to
switch on the alert. If the alert is on, the display shows ‘Off?’. Press
the OK button to switch off the alert.
If you have set the sound alert to ‘on’, the sound alert symbol ( R )
appears on the display of the parent unit.
Setting room temperature range
A baby will sleep comfortably in a room heated to a temperature between
61°F and 68°F. This is important, since a baby cannot regulate its body
temperature as well as an adult. A baby needs more time to adjust to
temperature changes.
If you do not set a temperature range, the baby monitor alerts you when
the temperature in your baby’s room drops below 57°F or rises above
86°F. In this case, the backlight of the parent unit display goes on and
‘High’ or ‘Low’ appears on the display. To change the default minimum and
maximum temperature, follow the instructions below.
Note: The temperature of the baby’s room is shown on the display of the
parent unit when they are linked.
1
Select ‘Temperature’ with the + and - buttons.
2
Press the OK button to confi rm.
,
,
,
,
ENGLISH
19
4222.002.7190.1.indd 19
4222.002.7190.1.indd 19
03-09-2008 14:31:01
03-09-2008 14:31:01