Barco R9002240 - Manual (Page 12)

Connections
3-2 5975688 BARCOVISION 1609S 131097
Signal Input Connection to the Projector :
- Composite Video
- S-Video
- RGBS or RGsB
- RGB3S or RG3sB (option)
- Component Video

   
&$Âu€
PAA PI
QPSUÃ
WD9@P
QPSUÃ#$
SB7ÃÃCW
Wƒp
S B 7
QPSUÃ%ÃS@HPU@
8PHHVID86UDPI
QSPE@8UPSÃHP9@ QPX@SH6DIT
QPSUÃ!
TWD9@P
&$Âu€
PI PAA
BS@@IГ)Г‚ƒr h‡v‚hy
S@9Г)Г†‡hqi’
QPSUÃ"
8‚€ƒCƒp
Only available when the optional Tri-level sync module is installed.
Port No Projector input Press Digit Button
1 Comp. Video 1
2 S-Video 1 /Comp. Video* 2
3 RGB 2 3
4/5 RGB 2 4 or 5
4/5 Component video 3 6
4/5 RGB with Tri level sync 4 7
4/5 Component video
with Tri-level sync 5 8
1 Input signal Y/C (luma/chroma)
2 Input signal : R, G and B with automatic sync
detection between seperate sync (separate
composite sync or with separate Hor and Vert.
sync) or sync on green (composite sync).
3 Input signal : R-Y, Y and B-Y with separate
composite sync or with separate Hor and Vert.
sync or with composite sync on Y.
4 Input signal : R, G and B with separate Tri level
sync or with Tri-level sync on green.
5 Input signal : R-Y, Y and B-Y with separate Tri
level sync or with composite Tri-level sync.
* Video or S-Video : switchable in the Picture
Tuning menu.
REMAINING
PROJECTOR
WARM UP
TIME
18.5 MIN
PLEASE USE
<EXIT> TO
LEAVE THIS
PROCEDURE
PROJECTOR WARM UP
A FULL WHITE PATTERN
WILL BE GENERATED FOR
20 MINUTES;
FOR IMMEDIATE USE OF
THE PROJECTOR, PRESS
<EXIT>
WARNING : SKIPPING THIS
PROCEDURE CAN REDUCE
THE INITAL PROJECTED
IMAGE.
THIOS OPTION CAN BE
DISABLED IN THE SERVICE
MENU
Start up with full white image.
The next menu will be displayed for 30 seconds.
a. Start up with warm up period.
If no action is taken, a white image will be displayed for 20 minutes.
This white image will be shifted on the faceplate of the CRT to avoid a CRT burn in.
During this warm up period, it is possible to interrupt this white image projection by
pressing the EXIT key. The previous menu will be repeated for another 30 seconds
but the remaining time will be indicated.
If EXIT is pressed, the remaining warm up period will be shipped.
During the warm up period, every 30 seconds a text box with the remaining time will
be displayed on the screen for 2 seconds. This text box will be displayed every time
on another place.
If another key, different from EXIT, is pressed, a text box with following text will be
displayed :
Please use <EXIT> to leave this procedure.
b. Start up without warm up period.
If the EXIT key is pressed, the warm up period will be skipped and the projector is
immediately ready for use.
Warning : skipping this warm up procedure can reduce the initial picture
quality of the projected image.