Barco R9002240 - Manual (Page 51)

9-1 5975688 BARCOVISION 1609s 131097
Options
9
IR Receiver 800
This infrared receiver unit makes it possible to control the
BARCOVISION 1609s from another room.
There is a communication line with cable between the IR receiver and
the projector or the RCVDS05. The control information from the RCU
can now be sent to this IR receiver.
The IR receiver 800 displays the selected source on a 7-segment
display.
Order number : R9827515
Hardwired RCU.
The control signals from the RCU can be sent to the projector via a
wired connection.
OPTIONS
shield
conductor
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-
jack 3.5 mm connectors (order number : R3131991).
- Peel back the vinyl covering of the cable on both sides and twist the
wire core.
- Solder a jack plug as shown in drawing above to each end of the
cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the
other side in the connector on the rear of the projector labelled
‘remote’.
Projector Control software
The software is user-friendly and makes full use of : mouse control,
pull down menus and dialog boxes.
Two main applications are available with this software : remote
control and transfering and receiving data of projector settings.
Remote Control Simulation. Advantage : address range 0 to 255.
Adjustment Data : where can it be located when a IBM PC (or
compatible) or MAC or Workstation is connected :
- hard memory device with files of settings.
- the contents of the local memory of the computer.
- the contents of the projector.
RCVDS 05 Source Selector
An optional RCVDS05 makes it possible to connect up to 20 sources
to the projector. When RCVDS's are linked via the expansion module,
even 90 inputs can be connected to the projector.
The selected source number will be displayed on a 2 digit display and
the selected input module will be indicated with a LED on the rear.
Order Numbers RCVDS 05: 110V: 9827888
9827889
220V: 9827880
9827881
VS05 Switcher
The VS05 is a versatile Video and HDTV source selector for all
BARCO's digitally controlled large screen projectors. It offers the
possibility to connect and switch up to 5 different Video sources, 3
different S-Video sources and 1 RGB Analog source to a BARCO
projector. In addition, the audio signal proper to the source, can be
switched to an audio amplifier.
Order Numbers: 110V: 9827890
220V: 9827899