InnoMax Hardside Fluid User Manual

Page 10

Advertising
background image

D.

Fill your waterbed, checking on it periodically, with warm water

to approximately one half inch below the top of the stand up safety

liner. Do not over fill the mattress. Shut off the water and remove

the hose.

E.

Remove the air bubbles inside the mattress. Do this by

"pushing" them with a broomstick towards the valve which is

"popped-up". Remove all the bubbles or they will create a

"sloshing" sound. You will have to remove air bubbles again in

about three days and also occasionally thereafter.

F.

Insert the plug and securely screw on the cap. Plug in your

temperature control system according to specific

manufacturer's instructions and turn the thermostat to 80 - 85.

Within 3 days, you can more accurately adjust up or down to

your personal comfort level.

G.

This close up photo shows how to insert your cap and plug

without allowing air to get in the mattress and without allowing

water to spill out. Your cap and plug may be a one piece design.

Not separate as shown.

SPECIAL SECTION: DRAINING YOUR WATERBED

ALWAYS UNPLUG YOUR WATERBED HEATER BEFORE

DRAINING OR FILLING YOUR WATERBED!

A.

First, unplug your heater.

Next, insert your garden hose with

waterbed hose connector into the "popped-up" valve, as pictured.

(Note: Photos show the standard syphon pump. However, for best

results and ease of draining, we suggest you rent an electric pump

available at InnoMax. For instructions on draining using an electric

pump refer to Electric Pump Draining Instructions on page 14.)

B.

Weigh down the area around the valve with a few heavy

objects, such as telephone books. This step will help prevent

air bubbles inside the mattress from getting in your garden hose

and stopping the siphoning action you will create.

C.

Mount your drain pump to your closest faucet and attach your

garden hose. Make sure your fittings are tight. With the "bell

valve" in the "up" position, turn on the water to put more water

in the mattress. This step pushes the air in your hose into your

bed so you can create the continuous water siphon you need.

(If you don't have a drain pump, see Draining without a drain

pump further instructions.)

9

Advertising