InnoMax Hardside Fluid - Manual (Page 3)

WARNING:
Never leave any infant, or handicapped
child who cannot turn over, unattended
on this or any other adult mattress.
Infant or handicapped children can
suffocate in the face down position or
get caught between the mattress and
frame, headboard or wall and suffocate.
STEP 1: BUILD THE FRAME
Panel Headboard or No Headboard
A. Lay out your frame and hardware. Note that the footboard
and backboard have grooved bottoms. The grooves should
face in toward each other. Make sure all frame boards have
finished surfaces facing down on the floor.
B. If your frame includes a headboard, attach it to the back
frame board using the slats and screws provided.
REMEMBER: The groove in the frame board must face inward
once the headboard is secured.
C. Assemble the frame with the corner brackets and screws
provided. Note the finished top to the frame is facing up.
D. Position your assembled frame exactly where you want it in
your room. Now refer to Step 2 - Building the Pedestal.
WATERBED ASSEMBLY INSTRUCTIONS WATERBED ASSEMBLY INSTRUCTIONS
NOTE: A mattress pad and linens are
very important to your waterbed. Not
only will it make it more comfortable, but
it stops the waterbed from robbing you
of natural body heat as well as soaking
up normal body oils that can deteriorate
your mattress over time.
Dimensions King Queen S.S.
Interior dimensions 72W x 84L 60W x 84L 48W x 84L
Exterior dimensions (panel H.B.) 75W x 87L 63W x 87L 51W x 87L
Exterior dimensions (bkcse. H.B.) 75W x 93L 63W x 93L 51W x 93L
DECKING
THE PEDESTAL
(Pedestal May Vary)
INTERNAL SUPPORTS
HEATER
CONTROL
THE MATTRESS
THE FRAME
THE SAFETY
LINER
TEMPERATURE
CONTROL PAD
THERMISTER
2