InnoMax Hardside Fluid - Manual (Page 11)

26 10
Electric Pump Usage/Draining Instructions: Unplug Heater Before Draining!
If interested in using an electric pump, please ask your dealer for more information.
1.
Remove all of the air from your mattress.
2. Attach the “perfect union” connector on the
end of the clear hose on the pump to the valve
in your mattress. Make sure all washers are
used and the connections are tight to maintain
proper suction.
3. Connect your exit hose to the discharge port
on the pump. Ensure the exit hose is in the
desired location. The force of the water can
actually cause the hose to flop about and come
out of a normal bathtub. Do not leave the hose
unattended while indoors. Place the pump on
a towel or cardboard piece to prevent possible
damage to the floor or other surface.
4. Plug the pump into a grounded electrical
outlet. Note: There is no on/off switch and
the pump will begin to operate immediately.
5. Allow the pump to run until the water
slows to a trickle. The pump will remove
nearly all of the water & the mattress will
become “vacuum-sealed” to ensure all
internal support features remain in their
proper location. Do not lift the head of the
mattress until the mattress is vacuum
packed, as this could damage the mattress.
6. Immediately unplug the pump. Do not run
the pump without water for an extended period
of time, as this can severely damage the pump.
7. Disconnect the perfect union connector
from the mattress and immediately insert
the cap and seal to ensure the mattress
remains vacuum packed.
If the mattress is still too heavy to move, you can utilize a shop (wet/dry) vacuum to get the remainder of the water out
Contact Your Dealer For Rental Info.
or To Purchase The Drain Hero™ -
10 Piece Maintenance Kit.
Unplug The Waterbed Heater Before Draining The Mattress
ELECTRIC PUMP DRAINING INSTRUCTIONS ELECTRIC PUMP DRAINING INSTRUCTIONS
D. Once water is flowing into the bed for a few seconds, turn the
"bell valve" to the "down" position, leaving the water flowing full
blast. The water from your faucet flowing through your drain
pump will suck the water out of your bed. This will take one or
two hours depending on water pressure. Do not allow air to get
in the hose.
E. If you have a motion reduced mattress you must show
special care while draining and moving your bed to prevent the
interior fiber layers from shifting.
F. FOLD YOUR MATTRESS CAREFULLY. DO NOT LET THE
FIBER LAYERS SHIFT OUT OF PLACE. If any shifting does
occur, you should reposition them before refilling your mattress.