InnoMax Hardside Fluid - Manual (Page 9)

STEP 7: FILLING THE WATER MATTRESS
A. From your bathroom faucet, remove the aerator by unscrewing
it. (If your bathroom faucet does not have an aerator, you will
have to use your kitchen faucet or an outside faucet.)
B. Attach the faucet connector you purchased with your
waterbed care kit, into your faucet. Next attach a garden hose
to the faucet connector. Make a tight fit to avoid spray leakage
(a towel placed over the faucet while filling will keep any
leakage from spraying.) To help eliminate unclean water in your
bed, flush running water though the garden hose for about 10
minutes before filling your bed.
C. Pour in your waterbed conditioner. Attach the waterbed hose
connector onto your garden hose. Insert it into your "popped-
up" valve and attach the hose connector and valve securely
together to avoid leakage. Wrap a towel around this connector
to soak up any unavoidable leakage.
8
STEP 6: INSTALL SAFETY LINER AND MATTRESS
A. Simply spread out the Stand-Up liner inside your frame. It will
stand-up inside the frame by itself.
B. Smooth out the wrinkles, especially over the heating pad!
C. Lay out your watermattress inside your safety liner with the
valve at the foot. Carefully avoid shifting any of the baffle
inserts, if you bought a motion reduced mattress. Remove the
wrinkles on the bottom and make sure the mattress is evenly
centered.
D. Align the corners of the mattress with the corners of the
frame. If your safety liner, heating pad, or thermostat sensor
shifted during this process, reposition it now.