InnoMax Hardside Fluid - Manual (Page 7)

STEP 3: LAY THE DECK BOARDS ON THE PEDESTAL
A. King size - position the three 24 inch deck board pieces so that
the pedestal is equally recessed on all sides. The cut corners on the
deck boards should be positioned at the four corners.
B. Queen size - position the two 24 inch deck boards, with the
one 12 inch deck board in the middle, so that the pedestal is
equally recessed on all sides. The cut corners should be posi-
tioned at the four corners.
C. Super Single size - position the two 24 inch deck boards so that
the pedestal is equally recessed on all sides. The cut corners on the
deck boards should be positioned at the four corners.
STEP 4: MOUNT THE FRAME TO THE DECK
A. Lower the frame onto the deck. Make sure the grooves on the
bottom of the footboard and backboard overlap the deckboards.
Re-check that the pedestal is centered and in position.
B. This photo shows how the grooves overlap the deck.
C. Attach the “L” bracket into the middle of each frame board
and deck to secure the deck to the frame. To protect liner and
mattress from metal burrs, cover all inside metal brackets with
masking or duct tape.
D. If your waterbed features a bookcase headboard, mount it to
the frame now. Secure the headboard to the frame with the flat
brackets screwed in from underneath the headboard behind the
frame. Slide the frame carefully away from the wall a few
inches, if needed, to allow more room to mount. Once mounted
slide the frame back into final position.
6