Hale RSD - Manual (Page 102)

❑ Option Maintenance
102 RSD Series Single-Stage PTO Pumps
p/n: 029-0020-92-0
IMPORTANT !
THE ADAPTER HOUSING IS BULKY AND HEAVY. BE PREPARED AS THE
SCREWS ARE REMOVED OR REQUEST AN ADDITIONAL PERSON ASSIST TO
PREVENT INJURY.
Servicing the Input Shaft
See Section 6b: RSD Gearbox, heading “Input Shaft and Gear Assembly”
on page 95.
Replacing the Oil Seal
The oil seal is located in the flywheel housing adapter. To replace:
1. Press out the existing seal from the flywheel adapter housing bore and
discard.
2. Insert a new seal, centered within the bore. (See Figure 6c-2: “RSD
Engine Drive Option,” on page 100.)
Installation Notes - Engine Mounting
❑ See WARNING ! note found on page 68.
❑ Exercise care when inserting the input shaft through the flywheel
housing and the elastomeric drive disc. DO NOT damaged the oil seal
and ensure proper alignment.
❑ When installing the flywheel housing adapter to the gearbox, make
sure the correct screws are installed (two sets of four of different
lengths). (See Figure 6c-2: “RSD Engine Drive Option,” on page 100.)
❑ Apply Loctite #242 to all screws and tighten in a criss-cross pattern to
ensure an EVEN seal. Refer to Table 6-1:“Typical Torque Values
Chart” on page 69 for recommended torque value.
❑ Inspect the system for proper operation before returning the apparatus
to service.