Hale RSD - Manual (Page 110)

❑ Glossary and Measurements
110
Appendix A: Glossary / Measurements
Hale Products, Inc., Nov. 2005, Rev.-A
Service Test........Pump test performed to determine if the apparatus can deliver its rated volume and
pressure.
Shrouds ..............Sides of an impeller that confine the fluid.
Slinger Ring........Prevents fluid from continuing to travel down a shaft to the gears and ball bearings.
Stages .................The number of impellers in a pump that are used in series; that is, one following another
in terms of flow. Each impeller develops part of the total pump pressure.
Tachometer ........Indicates the speed of the engine crankshaft in revolutions per minute.
Torque.................The force that acts to produce rotation.
Transfer Valve ...A two-position valve in a pump that changes the operation from parallel (volume) to
series (pressure) operation and vice versa (not used on single stage pumps).
Vanes ..................Guides inside an impeller that direct fluid to the volute (pump body).
Volute..................A gradually increasing discharge waterway. Its function is to collect the water from the
impeller and, depending on its design, it either increases pressure and decreases
velocity or increases velocity and decreases pressure.
Water...................Amount of energy in the water stream.
Horsepower
Wear Rings .........See Clearance rings.