Hale RSD - Manual (Page 29)

29 Section 3: Operating
Hale Products, Inc., Nov.2005, Rev-A
O p er atio n
❑
CAUTION !
DO NOT LEAVE THE CAB OR ATTEMPT TO PUMP UNTIL ALL THE GREEN PUMP
LIGHTS IN THE CAB ARE ON.
DO NOT OPEN THE THROTTLE UNLESS THE GREEN INDICATOR LIGHT IS ON.
(SEE FIGURE 3-2: “PUMP OPERATOR’S PANEL.”)
5. Exit the driving compartment only after all the preceding steps are com-
pleted and you are sure the appropriate lights in the cab and panel are ON.
6. Verify that the pump panel GREEN shift indicator OK TO PUMP light illumi-
nates and that all hose connections are complete.
Figure 3-2: Pump Operator’s Panel
For “Split-Shaft” operation
❑ After pump shift is completed place the truck transmission in the proper
pump operating range or gear. For most pumpers this is direct drive (1:1)
ratio. In addition, the speedometer should register after the shift has been
completed.
❑ If the shift does not complete, shift truck transmission back to NEUTRAL
(N) and repeat the entire procedure.
❑ Some vehicles drive the speedometer from the front wheel of the chas-
sis. In this case, the speedometer will not register after shifting to the
PUMP position. See the chassis manual for details.