OR-Fab 83238 JK WRANGLER HD FULL WIDTH CENTER WINCH FRONT BUMPER - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
JEEP WRANGLER (JK)
FULL / MID WIDTH FRONT WINCH BUMPER
INSTALLATION INSTRUCTIONS
2007 - 2013
CENTERED FAIRLEAD FOR REGULAR
WINCHES KIT # 83228 / 83230
NON-HOOP # 83238 / 83234
OFFSET FAIRLEAD FOR LARGER WINCHES
KIT# 83227 / 83229
NON-HOOP # 83237 / 83233
(WARN PowerPlant Included)
*2012+ Models Require 87046 Relocation
Kit*
WARNING
Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.
CAUTION
Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and
installation of original equipment components. We rec-
ommend that the factory shop manual and any special
tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
may affect the performance of these components and
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
ilar components install this kit.
WARNING
Many states and municipalities have laws restricting
bumper heights and vehicle lifts. Consult state and
local laws to determine if the changes you intend to
make to the vehicle comply with the law.
WARNING
Always wear eye protection when operating power
tools.
Jeep Wrangler JK Full / Mid Width Winch Bumper 1 Kit # 83227 / 228 / 229 / 230 / 233 / 234 / 237 /238
Before Starting Installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Instructions are written for installation of both
centered (83228/83230/83238/83234) and offset
(83227/83229/83237/83233) bumper. Pay close
attention for minor differences during install.
3. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
4. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
5. Park vehicle on a clean, dry, flat, level surface and
block tires so vehicle cannot roll in either direction.
Engine Compartment
1. Disconnect both battery cables. Disconnect nega-
tive cable first, then positive cable.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
NOTE
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover
4
3651 N. Hwy 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net