OR-Fab 87035 TIRE CARRIER T-HANDLE LICENSE PLATE RELOCATION BRACKET - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
JEEP WRANGLER
T-HANDLE LICENSE PLATE
RELOCATION KIT
INSTALLATION INSTRUCTIONS
1987-UP JK, TJ & YJ
KIT# 87035
WARNING
Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.
CAUTION
Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and
installation of original equipment components. We rec-
ommend that the factory shop manual and any special
tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
may affect the performance of these components and
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
ilar components install this kit.
WARNING
Always wear eye protection when operating power
tools.
WARNING
Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.
87-UP JK, TJ & YJ T-Handle License Plate Relocation 1 Kit #87035
Before Starting Installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Park vehicle on a clean, dry, flat, level surface and
block tires so vehicle cannot roll in either direction.
Prepare to Install Kit Bracket
1. Measure and mark T-Handle
a. Using a tape measure, measure your T-Handle
on your carrier and find center.
b. Once you have your over all length & center
marked; measure 4” apart from center and mark
two holes for drilling to 3/8”.
c. Double check the measurements of the marks
and drill each hole out to 3/8”.
NOTE
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover
T-Handle
Drill 3/8” Holes
Mark & Mearsure