ARB 3415010 - Manual (Page 12)

Last Rev Date:29/10/2008 Page 12 of 20 Fitting instructions# 3783250
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BULL BAR PREPARATION
39. Secure the number plate bracket using
M6 bolts, flat washers and flange nuts.
Attach the longer side to the bullbar and
the shorter side to the number plate.
40. Fit M8 cage nuts for stone tray in four
positions to inside face of lower pan.
FITTING PROCEDURE WINCH
If fitting winch.
41. The clutch handle must be repositioned
so it is in a convenient location when
mounted to bar.
Place the winch on its end and remove all
gearbox bolts.
Gently raise the motor just enough to rotate
it. Viewing from the gearbox end, rotate the
gearbox 72° clockwise.
Do not completely remove the motor and
avoid damaging the gasket. Refit and tighten
all bolts.
Note: Take care not to lift the assembly
more than a couple of millimeters while
rotating to the desired position to avoid
un-meshing the gears.
42. Remove cable retaining band and position
cable loop so it will go through roller
fairlead when it is placed in bull bar.
ORIGINAL POSITION NEW POSITION
ROTATION