ARB 3415010 - Manual (Page 19)

Last Rev Date:29/10/2008 Page 19 of 20 Fitting instructions# 3783250
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
80. Fit stone tray using 4 x M8 bolts and washer
sets at front and 2 x M8 bolts, washers and
into fitted M8 cage nuts at two locations into
existing sump guard front section as shown.
81. If winch fitted, fit off winch hook.
NOTE:
♦ Connect wiring to fitted sensors, lights and winch.
♦ Check operation of all lights.
♦ Check operation of parking sensors. If sensors do not function correctly refer to
steps 28 - 34 in notes.
♦ Adjust fog lamp beam aim.
♦ Check winch operation