ARB 3415010 - Manual (Page 9)

Last Rev Date:29/10/2008 Page 9 of 20 Fitting instructions# 3783250
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER
23. Mask up and spray paint the exposed metal
trim area black satin, from the wheel arch
right around to the inboard headlamp area as
shown, both sides of the vehicle.
NOTE: This is in the area where the bumper
cover retaining brackets were removed at step
22. When the bull bar is fitted there will be
25mm of this sheetmetal visible, the black
masks the visible gap.
FIT MOUNTING BRACKETS
24. Insert clevis nut into rectangular hole in the
inboard face of chassis, ensuring the
threaded end is inserted first.
The nut when fitted correctly should fit square
and locate into the chassis rail.
25. Install the chassis stud by fitting 2 nuts to the
end of the stud and tightening until thread
bottoms out.
26. Remove nuts and repeat for the LHS.
27. Loosely fit the mounting brackets to the
chassis securing with the 8mm packers and
flange nuts.
28. Secure using existing OE M10 flange nuts,
but do not do up tight .